Terminal Panel Features - NEC NP1250 User Manual

Terminal Panel Features

14
The actual appearance of the terminal panel may differ slightly from that shown in the drawing, but this does not af-
fect the projector's performance.
. COMPUTER  IN/Component Connector (Mini
D-Sub 5 Pin) ( → page 4, )
AUDIO IN (Stereo Mini Jack) ( → page 4, 5, )
. COMPUTER  IN/Component (R/Cr, G/Y, B/Cb, H,
V) Connectors (BNC × 5) ( → page 4)
AUDIO IN (Stereo Mini Jack) ( → page 4)
3. COMPUTER 3 (DVI-D) IN Connector (4 Pin)
(HDCP compatible) ( → page 5)
AUDIO IN (Stereo Mini Jack) ( → page 5)
4. COMPONENT IN (Y, Cb/Pb, Cr/Pr) Connectors
(RCA) ( → page )
AUDIO L/MONO, R (RCA) ( → page )
5. S-VIDEO IN Connector (Mini DIN 4 Pin) ( → page
8)
. VIDEO IN Connector (RCA) ( → page 8)
. VIDEO/S-VIDEO AUDIO L/MONO, R (RCA) ( → page
8)
8. MONITOR OUT Connector (Mini D-Sub 5 Pin)
( → page )
9. AUDIO OUT (Stereo Mini Jack) ( → page )
4 13 12
USB(LAN)
5 6 7 1
0. PC CONTROL Port (D-Sub 9 Pin) ( → page 58, 59)
. Remote Jack (Stereo Mini Jack) ( → page )
. USB Port (Type A) ( → page 3)
3. LAN Port (RJ-45) ( → page 9, 0)
4. USB Wireless LAN unit ( → page 0)
8
3 2
8 9
Use this port to connect your PC or control system
to control your projector via a serial cable. This
enables you to control the projector using serial
communication protocol. A commercially available
RS232C cross cable is required to use this port. You
can also control the projector by using PC Control
Utility 3.0 contained on the supplied User Support-
ware 6 CD-ROM. To do so you must first have PC
Control Utility 3.0 installed on your PC. If you are
writing your own program, typical PC control codes
are on page 158.
NOTE:
• Connecting the remote cable to the REMOTE mini jack
on the terminal panel will make the wireless operation
unavailable.
NOTE: A dummy cover is provided on this location of the
projector which does not come standard with the USB
Wireless LAN Unit.
1. Introduction
11 10