• ONLY CHARGE THE BATTERY IN A CLEAN, WELL VENTILATED
AREA.
Warning
Batteries may explode if not handled properly.
Do not disassemble or dispose of batteries in fire.
Do not short external contacts, crush, puncture or otherwise tamper
with batteries. Keep batteries away from children.
Follow local regulations when disposing of used batteries.
Precautions when replacing the battery
Improper replacement or mishandling could damage the battery,
cause overheating, result in injury, and risk fire or explosion.
• Device with built-in battery: A built-in battery must be replaced by an
authorized service center. Do not attempt to replace or remove the
battery by yourself.
• Device with removable battery: The battery should only be replaced
with parts approved by Acer. Do not replace the battery with any
parts other than approved ones.
This notebook uses a Lithium-based battery. Do not use it in a humid,
wet or corrosive environment. Do not put, store or leave your product
in or near a heat source, in a high temperature location, in strong
direct sunlight, in a microwave oven or in a pressurized container, and
do not expose it to temperatures over 50 °C (122 °F).
Failure to follow these guidelines may cause the battery to leak acid,
become hot, explode or ignite and cause injury and/or damage. Do
not pierce, open or disassemble the battery. If the battery leaks and
you come into contact with the leaked fluids, rinse thoroughly with
water and seek medical attention immediately. For safety reasons,
and to prolong the lifetime of the battery, charging will must not occur
at temperatures below 0 °C (32 °F) or above 35 °C (95 °F).
The full performance of a new battery is achieved only after two or
three complete charge and discharge cycles. The battery can be
charged and discharged hundreds of times, but it will eventually wear
out. When the operation time becomes noticeably shorter than
normal, check an authorized reseller to purchase a new battery.
First things first - 9
Need help?
Do you have a question about the Swift Go 16 and is the answer not in the manual?
Questions and answers
I can not access the @ symbol when I press the shift key and no. 2 key
The inability to access the @ symbol when pressing Shift + 2 on your Acer Swift Go 16 could be due to the keyboard layout setting. If your keyboard is set to a different layout (e.g., UK instead of US), the @ symbol may be assigned to a different key. To fix this, check and change your keyboard layout in Windows settings:
1. Press Windows key + Space to cycle through installed keyboard layouts.
2. Go to Settings > Time & language > Language & region.
3. Under Preferred languages, select your primary language, then click Keyboard options.
4. Ensure the correct layout (e.g., US QWERTY) is selected.
If the issue persists, try using Alt + 64 on the numeric keypad or check for any software-related conflicts.
This answer is automatically generated