Subscribe to Our Youtube Channel
Related Manuals for U.S. Solid JF-7000
Summary of Contents for U.S. Solid JF-7000
- Page 1 AUTO TAPE DISPENSER JF-7000 INSTRUCTION MANUAL For questions or concerns, e-mail service@ussolid.com, visit www.ussolid.com, or call 1-800-243-5428...
-
Page 2: Read Before Use
The safety guidelines in this Instruction Manual must be observed in order to prevent damage to the machine or Thank you very much for buying our tape dispenser JF-7000. It is injury to the operator or other persons. a very compact, special well equipped machine which can cut and dispense various kinds of tape, including non-adhesive The safety guidelines prescribed ”... -
Page 3: Identification Of Parts
Identification Of Parts Warning Do not plug in, unplug the cord, or operate the machine with HOLD DOWN ROLLER UNIT wet hands. Failure to observe this may result in injury due to electric shock. ROLLER LOCK LEVER UPPER CASE CONTROL PANEL Never insert your finger, or any other body part, or any foreign object into the machine. - Page 4 Identification Of Parts Load the Tape AC CORD ◆Plug in the AC CORD to the AC CORD INLET. INLET ◆Make sure the POWER SWITCH is off then plug into an appropriate TAPE FEED ROLLER grounded AC outlet. TAPE INLET ◆Turn the POWER SWITCH on. When the POWER SWITCH is turned on, a buzzer will has a sound.
-
Page 5: Mode Setting
P-MODE (Preset Mode) Set the Tape Length P-MODE The machine is able to be programmed. ◆Make sure that DISPLAY indicating <cutting length>. INDICATE CUTTING LENGTH INDICATE CUTTING LENGTH A signal will be shown based on your selected quantity of pieces and it will all The cutting length is always indicates in some alphabets like A,b,C,d,E,F. -
Page 6: Other Functions
How to Manage a Curling Tape Replace the Blade Unit REMOVE BLADE UNIT Only Blade is not accepted to be replaced. ◆Press the HOLD DOWN ROLLER RELEASE BUTTON in order to open It needs to change with the whole Blade Unit. the HOLD DOWN ROLLER UNIT. -
Page 7: Error Messages
Error Messages ROLLER UNIT When tape jammed, you can remove ROLLER UNIT wihtout using any tools and make sure The buzzer will has a sound then a message will flash and show on the about the status of Roller Unit. DISPLAY. -
Page 8: Troubleshooting
Trouble Shooting Before returning the machine for repairing, please check the followings. Remarks ◆The specifications are subject to change without prior notice. The POWER SWITCH is The AC CORD is loosen. Check the AC CORD then plug in the outlet firmly. ◆The length of the tape may differ from the set length depending upon on but the machine can The FUSE has been blown.
Need help?
Do you have a question about the JF-7000 and is the answer not in the manual?
Questions and answers