Replacing A Memory Module - Lenovo ThinkCentre M57 6086 Hardware Maintenance Manual

Replacing a memory module

This procedure describes how to remove and replace a memory module.
1. Remove the cover. See "Removing the cover" on page 89.
2. You might have to remove the drive bay assembly to access the memory
3. Remove the memory module being replaced by opening the retaining clips as
4. Position the replacement memory module over the memory connector. Make
5. Slide the drive bay assembly towards the rear of the chassis until it snaps into
6. Reinstall the front bezel.
7. Go to "Completing the FRU replacement" on page 112.
92
Hardware Maintenance Manual
connectors. See "Accessing system board components and drives" on page 90.
shown.
sure that the notch 1 on the memory module aligns correctly with the
connector key 2 on the system board. Push the memory module straight
down into the memory connector until the retaining clips close.
position.