Replacing The Power Supply - Lenovo ThinkCentre M57 6086 Hardware Maintenance Manual

Replacing the power supply

This procedure describes how to remove and replace the power supply.
94
Hardware Maintenance Manual
Attention
Never remove the cover on a power supply or any part that has the
following label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components.
1. Remove the cover. See "Removing the cover" on page 89.
2. Remove the drive bay assembly. See "Accessing system board components
and drives" on page 90.
3. Disconnect all power supply cables from the system board. See the system
board diagram for your machine type at "System board connectors" on page
88.
4. Remove the hard disk drive. See "Replacing the hard disk drive" on page 104.
Note: Observe the power supply cable routing underneath the hard disk
drive.
5. The system board must be moved out of the way to remove the power supply.
Remove the screws that secure the system board to the chassis and slide the
system board away from the power supply.
Note: You do not have to remove the system board from the chassis to
remove the power supply.
6. At the rear of the chassis, remove the three screws that secure the power
supply. Also remove the screw that secures the power supply at the front.