Selecting Or Changing The Startup Device Sequence; Advanced Settings; Exiting From The Setup Utility Program - Lenovo ThinkCentre M57 6086 Hardware Maintenance Manual

Note: Selecting a startup device from the Startup Device menu does not

Selecting or changing the startup device sequence

To view or permanently change the configured startup device sequence, do the
following:
1. Start the Setup Utility program (see "Starting the Setup Utility program" on
2. Select Startup.
3. Select Startup Sequence. See the information displayed on the right side of the
4. Select the devices for the Primary Startup Sequence, the Automatic Startup
5. Select Exit from the Setup Utility menu and then Save Settings or Save and
If you have changed these settings and want to return to the default settings, select
Load Default Settings on the Exit menu.

Advanced settings

On some computer models the Advanced settings menu includes a setting to
Enable/Disable HyperThreading. This feature works only with
HyperThreading-aware operating systems, such as Microsoft Windows XP and
Windows Vista
you select Set Defaults and are using an operating system other than Windows XP
or Windows Vista, the computer performance might be degraded. Therefore, you
should always set HyperThreading to Disabled unless you are sure your operating
system supports HyperThreading.

Exiting from the Setup Utility program

When you finish viewing or changing settings, press Esc to return to the Setup
Utility program menu (you might have to press Esc several times). If you want to
save the new settings, select Save & Exit Setup before you exit. Otherwise, your
changes will not be saved.
permanently change the startup sequence.
page 51).
screen.
Sequence, and the Error Startup Sequence.
exit the Setup Utility.
™
. The default setting for HyperThreading is Enabled. However, if
Chapter 6. Using the Setup Utility
53