Table of Contents
Advertisement
Operating Procedures
2-22
8 — Fonts at startup (for each interface)
This shows the font automatically selected when the printer starts up (default font). It is possible to set
different fonts for the parallel interface and the serial interface. The figure on page 2-20 shows default
settings. The font is set to "1" (Courier bitmap font).
This also shows font information similar to the column below if an optional interface is installed.
9 — KIR test pattern
This is used when setting the printer's KIR mode. For details, see page 2-58.
10 — User font list
Following the status page, font listings are output which show the fonts which have been downloaded
to the printer from the computer.
10
Advertisement
Table of Contents
