Kyocera FS-7000+ User Manual page 126

4.
The same procedure can be used to set the parameters on other submenus.
Note that the setting status for paper weight and fuser mode used for each paper type is as given in
the table below. In addition, all paper type settings made using Custom setup can be reset to
the default values shown in the table below using the >Reset custom setup menu.
Paper Type
Plain Trans-
parency*
Fuser
Vellum
mode
Low \
Middle
High \
Paper Light
weight (Thin)
Normal \
Heavy \
(Thick)
*: These cannot be selected when the paper source is EF-1 or UF-1.
Pressing the ENTER key will cause the ? to disappear. Pressing the EXIT key will exit the setting.
Pre- Labels Bond Recycled Vellum* Rough
printed
\
\ \
\
\ \ \ \
Chapter 2 Operating the Page Printer
Letter Color
head
\
\
\ \
\
\ \ \
Pre- Envelope Card Custom
punched stock
\ \
\ \
\ \ \
\
2-55