Inflating - Advanced Elements AdvancedFrame AE1007-R Owner's Manual

3.3
IMPORTANT
your kayak in the following order. Failure to follow these instructions may cause damage to
1. Starting with Chamber 1, check to be sure that the valve plunger is UP or in the INFLATE
position (See Figure 1 on previous page). Inflate until the kayak begins to lift off of the
ground and take shape, then close cap.
NOTE: This will be a minimal amount of air pressure. DO NOT inflate this chamber to 2.0 psi!
2. Move to Chamber 2 on inside of kayak and inflate until firm to touch (2.0 psi ONLY).
3.
closed when complete
NOTE: Your floor comes equiped with a Pressure Relief Valve. It is located at the rear of the
floor and can be identified by the red cap at the top of it. DO NOT REMOVE THIS CAP!
Should the pressure in the floor chamber exceed the recommended rating, this valve will
open slightly to release some pressure to avoid damage to your floor.
4.
This chamber can be moved forward or backward when paddling solo.
5.
6. Make sure all valves are closed tightly and properly.
7. Finally, Insert Plastic Bow and Stern forms into pocket on bow and stern (Figure 3).
10
(See Figure 2 on previous page). (1.0 psi ONLY)
ONLY