Preparing The Remote Control - JVC UX-G70A Instructions Manual

⁄
Digital audio component
Protective cap
• Set "DIGITAL AUDIO OUTPUT" in the "AUDIO" menu
correctly according to the connected digital audio
equipment (see page 34). If the setting is incorrect, loud
noise may be generated causing damage to the speakers.
• Digital audio signals are output from this System only when
"DVD/CD" is selected as the source.
@
Speakers
• When connecting the speaker cords, match the polarity of
the speaker terminals: red color to (+) and black color to (–).
Insert
From right
CAUTION:
speaker
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
Press and hold
Release
Red
From left
Black
speaker
When connecting a portable audio device (LINE)
Portable audio device
(Digital Audio Player, etc.)
To the audio output
Portable audio device with
the audio input
(Digital Audio Player, etc.)
• By using QP Link (Quick Portable Link), you can easily
start playing back a portable audio device on this unit when
connecting it to the LINE IN jack. See page 12 for details.
• Connect an audio component to the LINE OUT jack if the
component is not equipped with a digital input terminal.
• If an external device is not equipped with a stereo mini plug
audio output, use a plug adaptor to convert the stereo mini
plug to the corresponding plug of the audio output.

Preparing the remote control

R6(SUM-3)/AA(15F)
• Dispose of batteries in the proper manner, according to
federal, state, and local regulations.
DO NOT recharge, short, disassemble, heat
the battery or dispose of it in a fire.
When using the remote control
Point the top of the remote control toward the remote sensor
as directly as possible. If you operate it from a diagonal
position, the operating range (approx. 5 m) may be shorter.
At the front panel
Stereo mini plug
(not supplied)
To the audio input
5