Preparing The Remote Control; Changing The Color System And Scanning Mode - JVC CA-MXDK51 Instructions Manual

@
Voltage Selector
Use a screwdriver to rotate the voltage selector so that the
voltage mark is pointing to the same voltage as where you
are plugging in the unit. (See also the back cover page.)
When your mains lead (AC)
line voltage is 230-240V
Voltage mark
When your mains lead (AC)
line voltage is 110V
Voltage mark
DO NOT plug in before setting the voltage
selector on the rear of the unit and all
connection procedures are complete.

Preparing the Remote Control

R6(SUM-3)/AA(15F)
DO NOT recharge, short, disassemble, heat
the battery or dispose of it in a fire.
When your mains lead (AC)
line voltage is 220 V
Voltage mark
When your mains lead (AC)
line voltage is 127 V
Voltage mark
• Dispose of batteries in the proper manner, according to
federal, state, and local regulations.
When using the remote control
Point the top of the remote control toward the remote sensor
as directly as possible. If you operate it from a diagonal
position, the operating range (approx. 5 m) may be shorter.
Changing the Color System and
Remote
Scanning Mode
ONLY
You can select the video output to match the color system of
your TV (PAL or NTSC).
Also, this System supports progressive scanning. If you
connect a progressive TV through the COMPONENT jacks,
you can enjoy a high quality picture from the built-in DVD
player by selecting "PAL/NTSC PRG."
1
Change the source to DVD/CD.
2
Enter the color system setting mode.
(While holding...)
3
Select the color system and scanning mode.
PAL/NTSC Interlaced scanning.
For a conventional TV.
PAL/NTSC PRG Progressive scanning.
For a progressive TV.
• PROGRESSIVE indicator lights on when progressive
mode is selected.
4
Store the setting.
INFO
PAL PAL PRG
NTSC PRG NTSC
6