Preparing The Remote Control - JVC UX-GP7V Instructions Manual

Micro component system
Table of Contents

Advertisement

To connect the powered subwoofer
From the powered subwoofer
(not supplied)
The connected subwoofer can reproduce the bass sounds
recorded in front left and right channels, but cannot
reproduce the LFE signals encoded in multi-channel
software.
• Before plugging the System to the power supply, make
sure that the powered subwoofer is turned off.
@
TV/monitor
Connect the COMPONENT jacks, S-VIDEO jack, or
VIDEO jack; whichever you want to use.
• You can get better picture quality in the order of—
Composite video ] S-Video ] Component video.
Red
Blue
• This connection allows you to use the progressive
scanning mode. To select progressive (PROGRESS)
scanning mode (see page 17), use VIDEO OUT
(COMPONENT) jacks.
Composite video cord
(supplied)
S-Video cord
(not supplied)
• After connecting a TV, select the appropriate video
signal output according to the connection method. See
"Changing the Color System and Scanning Mode" on
page 17.
When connecting a digital audio player
On the front
panel
From audio output (or headphone out, etc.)
Green
Component video cord
(not supplied)
Stereo mini plug
(not supplied)
When connecting an iPod
On the front panel
Dock adapter (supplied with
the iPod or sold separately)
• It is not encourageable to connect or disconnect the
iPod when the System is turned on.
• Be sure to reduce the volume on the System to the
minimum level before connecting an iPod. Adjust the
volume after starting playback.
To detach the dock adapter from the dock
Pull up the dock adapter with your fingernail or a sharp
pointed tool using the slot.
• Be careful not to injure your fingertips or damage the
terminal of the dock.

Preparing the remote control

Insert the battery into the remote control by matching the
polarity ( + and –) correctly.
If the range or effectiveness of the remote control decreases,
replace both batteries.
Caution
Battery shall not be exposed to excessive heat such as
sunshine, fire, or the like.
When using the remote control
Point the top of the remote control towards the remote
sensor as directly as possible. If you operate it from a
diagonal position, the operating range (approx. 5 m) may
be shorter.
Apple iPod
(separately purchased)
6

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ca-uxgp7vSp-uxgp7v

Table of Contents