Rear Panel; Side Panel - JVC DT-V1710CG/E Instructions Manual

CONTROLS AND FEATURES
19
Power lamp
Unlit : The main power is OFF.
Orange : The main power is ON, but the monitor's power
is OFF (in stand-by mode).
Green : The main power is ON, and the monitor's
power is ON (in normal operation mode).
REAR/SIDE VIEW
<Rear Panel>
REMOTE
MAKE/TRIGGER
G / Y
SWITCHED
OUT
IN OUT
B/P /B-Y
B
IN
HD SDI 1
IN OUT
R/P /B-Y
R IN OUT
IN OUT
HD/C
S
IN
IN OUT
VD
HD SDI 2
AUDIO
IN IN OUT OUT
AUDIO
IN OUT
IN OUT
MAIN POWER
(Rear view of DT-V1910CG shown)
REMOTE (external control) terminals
21
Terminals for controlling the monitor from an
external unit.
MAKE/TRIGGER terminal:
Enables the monitor to be controlled by closing the
circuit (point of contact) connected to the terminal.
RS-485 IN terminal:
Enables the monitor to be controlled from a personal
computer via a serial cable.
RS-485 OUT terminal:
Enables a cascade control connection. Multiple moni-
tors can be controlled by the device connected to the IN
terminal.
Input card slots (SLOT 1 – SLOT 3)
22
Optional input cards can be installed in these
slots. Input cards are not provided when you
purchase the monitor.
NOTE:
It is not possible to input video or audio signals to the monitor
when no input cards are installed.
Main power switch
23
Press the switch to turn the main power ON or
OFF. When the main power is ON, the power
lamp on the front panel lights in yellow and the
monitor enters the stand-by mode.
• I : ON : OFF
6
21
RS-485
22
23
24
20
POWER switch
Press the power switch to turn the monitor's
power ON or OFF when the main power is ON.
NOTE:
When RUSH DELAY TIME is set to SLOW in the set-up menu, it
takes approx. 3.2 seconds for the power to actually turn ON after
the power switch is pressed.
<Side Panel>
25
(SIde view of DT-V1910CG shown)
24 AC inlet
Power input connector. Connect the provided AC
power cord to an AC outlet (220 V AC, 50 Hz/60 Hz).
* Attach the provided Power Cord Holder to prevent
accidental disconnection of the AC power cord.
Refer to page 12 for details.
25 Built-in speaker (monaural)
Outputs the selected INPUT audio signal.
(cont'd)