Index Of Parts And Functions; Rear Panel - JVC DT-E15L4 Instructions Manual

Index of Parts and Functionos

Rear panel

1 REMOTE terminal
Terminal for controlling the monitor by an external control (☞ "External Control" on page 22).
2 VIDEO terminals (BNC)
Input (IN) and output (OUT) terminals for the composite signals.
3 E. AUDIO HD/SD SDI (IN 1, IN 2) terminals (BNC)
Input terminals for the HD/SD SDI signals.
●
The terminals accept also EMBEDDED AUDIO signals including up to 16 audio channels with a sampling frequency of 48 kHz.
4 E. AUDIO HD/SD SDI (SWITCHED OUT) terminal (BNC)
Output terminal for the HD/SD SDI signals.
●
The SDI signals of the current input (SDI 1 or SDI 2) are re-clocked, then emitted.
●
When an input other than SDI 1 and SDI 2 is selected, the SDI signal of the input selected last time is emitted from this terminal.
●
The signals are emitted from this terminal only when the monitor is on or in "Power Save" (power save) mode(☞ "No Sync Action" on
page 17).
5 HDMI terminal
Input terminal compatible with HDCP for the HDMI signal. (☞ page 30)
6 COMPO./RGB terminal (mini D-sub 15pin)
Input terminal for the analog component signal or analog RGB signal. (☞ page 30)
●
Set "Component/RGB Select" (☞ page 15) appropriately for input signals.
7 AUDIO (IN) terminals (pin jack)
Input terminals for the analog audio signals.
●
Use this terminal for the analog audio connection of the SDI. When inputting audio into this terminal, set "SDI-1 Select" or "SDI-2 Select" of
the menu to "1ch+2ch", "1ch" or "2ch" (☞ page 16).
●
When you use HDMI input for the picture and analog sound for the audio signal, input analog sound into this terminal, and set "HDMI
Select" of the menu to "1ch+2ch", "1ch" or "2ch" (☞ page 16).
8
Security slot
Attach a security wire to this slot.