Table of Contents
Advertisement
Front panel
Remote sensor:
Eco sensor:
Rear panel
REMOTE terminals
Connect external control equipment (see pages 8, 17 to 19).
AUDIO OUT terminals
Connect external speakers or audio equipment.
EXT. SPEAKER terminal:
Connect external speakers (commercially available) (see page 6).
• To use this terminal, set "SPEAKER SELECT" on the main menu to "EXT. (external)" (see page 12).
MONITOR OUT terminals:
Connect to the audio input terminals of audio equipment such as an amplifier
(see page 8).
Point the front end of the remote control toward here.
Detects brightness of the room (see page 13).
Self-diagnostic lamps:
These lamps light/flash if something abnormal
occurs with the monitor (see page 21).
Power lamp:
When the monitor is turned off: Unlit.
When the monitor is turned on: Lights in green.
When the monitor is in sleep mode: Flashes in
orange.
When the monitor is in standby mode: Lights in
orange.
Input card slots (SLOT-1, SLOT-2):
Optional input cards can be installed in these slots.
• For details about input cards, refer to the
instructions of the input card.
RS-232C terminal:
Connect to the RS-232C terminal of a
personal computer.
RS-485 terminals:
IN terminal:
Connect external control equipment.
OUT terminal:
Connect another component to send
out the control signal coming into the IN
terminal (cascade connection).
1
(Power) button: Turns the monitor on/off (see page 9).
2 INPUT button:
Changes inputs (see page 9).
3 MENU button:
Displays the main menu (see page 10).
4 5/∞ buttons:
Selects an item on the menu (see page 10).
5 +/– buttons:
Adjusts the volume level (see page 9).
• When the menu is displayed, adjusts the value (see page 10).
6 SET-UP button:
Displays the set-up menu (see page 10).
AC IN terminal:
Connect the supplied power cord (see page 8).
POWER switch:
I : Turns on the main power. (The power can be
‡: Turns off the main power.
AUDIO IN A/B terminals
Connect audio output terminals of equipment such as a
VCR (see page 8).
AUDIO IN A terminal
AUDIO IN B terminal
VIDEO IN A/B terminals
Connect video output terminals of equipment such as a VCR (see page 8).
VIDEO IN A terminal
IN terminal (BNC):
Connect to the video output terminals of playback equipment such as a VCR.
OUT terminal (BNC): Connect to the video input terminal of another monitor, etc.
Y/C IN terminal (Y/C): Connect to the S-video output terminal of playback equipment such as a
VCR.
• When both IN terminal and Y/C IN terminal are used, the input to the Y/C IN terminal has priority.
VIDEO IN B terminal
RGB/COMPO. terminal (D-sub 15-pin) *
1
: Connect to the video output terminal of a personal
computer or playback equipment such as a VCR *
DVI-D terminal (DVI-D) *
1
:
Connect to the digital output terminal of a personal computer.
*1 When connecting to a personal computer, use a cable with ferrite cores and no longer than of 3 m (118
electromagnetic disturbance.
*2 You may need a conversion cable (commercially available).
controlled by POWER ON/OFF buttons on the remote
control or
button on the main unit.)
R, L/MONO terminals (pin jack):
Connect to the audio output terminals of the
equipment connected to the VIDEO IN A terminal.
(Connect only the L/MONO terminal for monaural
sound.)
STEREO terminal (stereo mini jack):
Connect to the audio output terminals of the
equipment connected to the VIDEO IN B terminal.
2
.
1
/
") to avoid
8
5
Advertisement
Table of Contents
