Necessary Settings before Use
Access/Charge
Lamp
Set Lever
Be sure to configure the following three
settings before use.
Charging the Battery Pack
1
Set the power/mode switch to OFF.
Slide while pressing down the lock button.
2
Attach the battery pack.
Slide the battery pack down until it locks
in place.
BATT.
1
Power/Mode
Switch
OFF
(CHARGE)
3
Connect the AC adapter.
AC Adapter
•
The access/charge lamp blinks to
indicate charging has started.
•
When the lamp goes out, charging is
finished. Unplug the AC adapter from the
AC outlet and disconnect the AC adapter
from the camera.
Required charging / recording time
(approx.)
Battery pack Charging time
BN-VF815U
2 hr. 40 min.
(Provided)
BN-VF823U
3 hr. 50 min.
BN-V840U
BN-V856U
* When using the viewfinder.
8 To detach the battery pack
Slide and hold BATT. (Z step 2), then
remove the battery pack.
8 To check the remaining battery power
See page 18.
DC Connector
To AC Outlet
(110V to 240V)
Recording
time
1 hr. 20 min.
(1hr. 25 min.*)
2 hr. 00 min.
(2 hr. 10 min.*)
3 hr. 45 min.
—
(4 hr. 00 min.*)
5 hr. 25 min.
—
(5 hr. 40 min.*)