Hussmann Ingersoll Rand User Manual page 335

Figure 13
Figure 14.
Hussmann Aftermarket
12. Leave the terminal box cover
attached to the box while knocking
out the electrical connector holes.
With a flat bladed screwdriver tap
around the knock outs required to
make the electrical connections.
IMPORTANT: DO NOT TRY TO
KNOCK OUT ANY HOLES WITH THE
TERMINAL BOX COVER REMOVED
OR THE BOX COULD BE DAMAGED.
BE SURE TO KNOCK OUT ALL
HOLES WITH THE COVER IN
PLACE.
Once the holes are knocked out, then
remove the cover.
Spacer washers ( F ) and ( G ) have been
provided if the electrical connectors are
smaller than the holes.
13. Install the SE-B on the din rail
bracket. Attach the two thermistor wires to
the sensor connectors using a 7mm nut
driver or socket.
Refer to the wiring diagram in Figure 27 for
connections for the motor protector.
page 7 of 18 4/7/2006