2.7V’s or below 0.4V’s, the device will register that an event occurred. It is important to choose a reading rate that is faster than the event could occur, to ensure that it will be captured by the data logger. The OM-CP-EVENT101A can accept up to 30VDC continuous.
- Screw the enclosure back together securely. Note: Be sure not to over tighten the screws or strip the threads. Recalibration The OM-CP-EVENT101A has a digital input signal and cannot be calibrated. A certificate of conformance can be provided. Installation Guide Installing the Interface cable - OM-CP-IFC200: Insert the device into a USB port.
Page 4
WARNING: FIRE, EXPLOSION, AND SEVERE BURN HAZARD. DO NOT SHORT CIRCUIT, CHARGE, FORCE OVER DISCHARGE, DISASSEMBLE, CRUSH, PENETRATE OR INCINERATE. BATTERY MAY LEAK OR EXPLODE IF HEATED ABOVE 100 °C (212 °F). Specifications subject to change. See Omega’s terms and conditions at www.omega.com...
Page 5
Fax: (203) 359-7700 e-mail: info@omega.com For Other Locations Visit omega.com/worldwide The information contained in this document is believed to be correct, but OMEGA accepts no liability for any errors it contains, and reserves the right to alter specifications without notice. WARRANTY/DISCLAIMER OMEGA ENGINEERING, INC.
Need help?
Do you have a question about the OM-CP-EVENT101A and is the answer not in the manual?
Questions and answers