replace an
existing ADF
lid
use the ADF
two-sided printing accessory
attach the two-
sided printing
accessory
accessories
If you remove the ADF lid for any reason, you can easily replace it.
to remove the ADF lid
1
Gently pull the ADF input tray straight out.
2
Open the ADF lid.
3
Pull up both tabs.
4
Remove the ADF lid by gently pulling it slightly forward as you lift.
tab above
each hinge
5
Follow the steps, above, labeled "to install the ADF."
1
Place all originals in the ADF input tray print-side up.
2
Adjust the paper-width guide to fit the size of your original.
A message appears on the display indicating that the originals are
loaded.
This accessory can be used with or without the optional 250-sheet plain
paper tray to provide dual-sided copying capability and dual paper tray
capacity. The 250-sheet plain paper tray can handle 250 sheets of copier
letterhead and bond paper. You must use the main paper tray to load
transparency film, photo paper, or other coated stock.
Tip! You must have the two-sided printing accessory installed
to use the optional 250-sheet plain paper tray.
1
Turn the knob on the rear access door of your HP Digital Copier
counterclockwise, then remove the door.
hp digital copier series
hinges
29