Table of Contents
Advertisement
3.
Connect the power cable (1) and data cable (2) to the back of the hard drive.
Figure 6-31
CAUTION:
sharp bend can break the internal wires.
4.
Place the hard disk drive cage into the chassis (1), then slide it down toward the bottom of the
chassis until it locks into place (2).
Figure 6-32
62
Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
Connecting the Hard Drive Cables
Never crease or bend a SATA data cable tighter than a 30 mm (1.18 in) radius. A
Installing the Hard Drive Cage
Hide quick links:
Advertisement
Table of Contents
