Installing An Internal 3.5-Inch Hard Drive - HP Pro 3005 MT Maintenance And Service Manual

Installing an Internal 3.5-inch Hard Drive

1. Follow the steps in
drive cage and, if necessary, the existing hard drive.
2. Slide the new drive into the hard disk drive cage (1), aligning the drive with the four screw holes
on the cage. Install the four 6-32 standard screws that secure the hard disk drive to the hard disk
drive cage (2). Make sure the hard disk drive cables are facing the top of the drive cage.
NOTE:
old drive to install the new drive.
NOTE:
are installed on the interior of the front bezel. The 6-32 screws are silver. Refer to
Additional Drives on page 50
Figure 6-30
Removing an Internal 3.5-inch Hard Drive on page 57
If you are replacing an old drive with a new drive, use the four retainer screws from the
If you are installing a second hard drive, use four of the extra standard 6-32 screws that
for an illustration of the retainer screws location.
Installing the Hard Drive in the Drive Cage
to remove the hard
Installing
Drives 61