Turbo Setting; Lumectra Lighting - PowerA Lumectra Overpowered OPS V3 User Manual

TURBO SETTING

EN
6
A. Press and hold one of the A, B, X, Y
buttons that you wish to set to Turbo.
B. While holding down the desired
button, press the Turbo button.
C. The Program Status LED will flash 3
times to indicate Turbo has been set.
D. Press the Turbo button again to turn
Turbo off.
LEDS - PROGRAM FUNCTION
The controller has 4 separate lighted Lumectra Zones that you can
customize:
Zone 1 Zone 2
Zone 3 Zone 4
1. Outside of program mode, pressing LEDs once will turn all LEDs on
or off.
2. To enter LED Program Mode on the controller, hold the LEDs
button on the back of the controller for 2 seconds.
3. The current programmable Zone will flash 3 times once in LEDs
programming mode. To toggle through the 4 Zones, press RIGHT
on the D-Pad. (Zone One is the default starting zone.)
4. Select one of the A/B/X/Y buttons to choose your color: green,
red, blue, or yellow.
5. Next, continue pressing the selected A/B/X/Y button to toggle
through 6 shades of that color.
6. Press LEFT on the D-Pad to program the zone's light effect:
"Solid", "Breathing", or "Cycle".
7. Press UP or DOWN on the D-Pad to adjust that zone's brightness
level.
8. In program mode, press LEDs once to turn off the current zone
independently of the other zones. If the current zone is set to "off",
press LEDs once to turn the zone back on.
9. Press the SELECT button to toggle through multiple speed
settings for the current zone. Press the START button to toggle
through multiple speed settings for all 4 zones simultaneously.
NOTE: This feature is only available in "Breathing" and "Cycle"
modes.
10. While in program mode, press LB to sync all zones to the same
lighting mode and toggle all zones through the 3 lighting modes
simultaneously; press RB to sync all zones to the same color and
toggle all zones through the 24 colors and shades simultaneously.
11. While in program mode, press LT to decrease the brightness of all
zones simultaneously; press RT to increase the brightness of all
zones simultaneously.
12. While in program mode, hold LEDs for 2 seconds to save any
changes made to light settings. All 4 LED zones will flash 3 times to
indicate the controller is now out of LED program mode. NOTE: The
controller will store the 2 most recently saved LED light settings.
13. Outside program mode, double press LEDs quickly to toggle between
the 2 most recently saved light settings.
14. Outside program mode, press LEDs once to turn all LEDs on or off.
The LEDs will display the most recently used selection of saved
settings.