Enterasys AP3630 Mounting page 2

Enterasys Wireless Standalone 802.11n AP
Initial startup
When power is first supplied, the AP attempts to reach the DHCP server on the network to acquire
the IP address.
• If the AP successfully reaches the DHCP server, the DHCP server assigns an IP address to the AP.
• If the DHCP assignment is not successful in the first 60 seconds, the AP returns to its default IP
address (192.168.1.20).
The AP waits for 30 seconds in default IP address mode before again attempting to acquire an
IP address from the DHCP server.
The process repeats itself until the DHCP assignment is successful, or until an administrator
assigns the AP an IP address, using static configuration. For more information, see the Enterasys
Wireless Standalone 802.11n AP User Guide.
Logging on to the AP
To access the AP, you must log on using a valid user ID and password. The default user name and
the password are:
User Name — admin
Password — new2day
By default, DHCP is enabled on the AP. To log on, use the IP address according to your network
DHCP IP address assignment. If the AP cannot get an IP address by DHCP, use the default
192.168.1.20 IP address. Depending on your network conditions, you can access the AP by either
of the following two methods:
• Web-based GUI
• Command-line interface via SSH connection
Note: The AP does not support unsecured Telnet connections.
Access the AP using the Web-based GUI
1. In a Web browser, type the following:
https://<static or DHCP provided IP address>
The Login screen displays.
P/N: 9034557-01
Enterasys Wireless Standalone 802.11n AP Installation Instructions
2. Enter the default User Name and Password in their respective fields.
3. Click Login.
You are now logged-in to the AP as an administrator.
Note: Enterasys Networks strongly recommends that you change your password the first time you
log in. For more information on changing the password, see the Enterasys Wireless Standalone
802.11n AP User Guide.
Access the AP using command-line interface via SSH connection
1. In your preferred SSH application, enter the AP's IP address and open the connection.
The SSH terminal opens and prompts you to Login as.
2. Enter admin at the Login as prompt and press Enter.
The software prompts you to enter your password.
3. Enter new2day at the password prompt and press Enter.
The AP enters Exec mode and logs you in. For more information on the AP CLI modes, see the
Enterasys Wireless Standalone 802.11n AP CLI Reference Guide.
Note: Enterasys Networks strongly recommends that you change your password the first time you
log in. For more information on changing the password, see the Enterasys Wireless Standalone
802.11n AP User Guide.
Enterasys Networks, Inc.