Removal and Replacement Procedures
5.22 Modem Cable
The modem cable is included in the Cable Kit (spare part number
253946-001).
1. Prepare the computer for disassembly (Section 5.3).
2. Remove the system board (Section 5.21).
3. Turn the system board bottom side up with the rear panel
facing forward.
4. Disconnect the modem cable 1 from the modem and route it
from between the modem connector 2 and the memory
expansion 3 and video memory connectors 4 (Figure 5-35).
5. Remove the tape 5 that secures the modem cable to the
system board.
6. Disconnect the modem cable from the system board 6.
Figure 5-35. Removing the Modem Cable
Reverse the above procedure to install the modem cable.
5–48
Maintenance and Service Guide