Yacht Controller MAXIMO Installer's Manual
Gear interface for engines equipped with mtu-sturdy electronic
Hide thumbs
Also See for MAXIMO:
- Installation manual (43 pages) ,
- User manual (29 pages) ,
- Installer's manual (6 pages)
Advertisement
Quick Links
Installer's guide
GEAR Interface for engines equipped
with MTU-Sturdy electronic
Version 1.1
Office - 4545 Ponce De Leon Boulevard - Coral Gables, FL 33146
Showroom - 1300 SE 17th Street - Fort Lauderdale, FL 33316
Phone: 305.667.5811 Fax: 305.663.5551 Toll Free: 888.898.8608 www.YachtController.com
Advertisement
Related Manuals for Yacht Controller MAXIMO
Summary of Contents for Yacht Controller MAXIMO
- Page 1 Installer’s guide GEAR Interface for engines equipped with MTU-Sturdy electronic Version 1.1 Office - 4545 Ponce De Leon Boulevard - Coral Gables, FL 33146 Showroom - 1300 SE 17th Street - Fort Lauderdale, FL 33316 Phone: 305.667.5811 Fax: 305.663.5551 Toll Free: 888.898.8608 www.YachtController.com...
-
Page 2: Safety Precautions
Thank you for your purchase of the Yacht Controller system. We are sure you will be well pleased with its operation and your wireless control of your yacht. If we can be of assistance to you at any time please do not hesitate to contact us via e mail. - Page 3 If it is necessary to access the control unit electronics to check or to insert the module, proceed as follows: 1. Disconnect power to Supremo or Maximo central unit and, if present, remove all cables located in front of the device.
-
Page 4: Installation Procedure
Installation procedure • Connect the wires of the Supremo or Maximo central unit (power supply and any wires of the bow thrusters, stern thrusters and winch) as described in the installation manual. • Wire two extension cables (one for the right engine, one for the left engine) of five wires each (1 mm2 in diameter) from the installation point of the Supremo or Maximo central unit to the MTU-Sturdy control units in the engine room. - Page 5 • Connect the two power supply wires of the extension cable to the power supply of the Supremo or Maximo central unit, as illustrated in figure 3. ATTENTION: Since the wires of the extension cable will probably have different colors from those we use, to avoid connection errors that could damage the equipment, note the color combination in the table in figure 1.
- Page 6 • Disconnect the connections shown in figure 5. Figure 5 • Connect the female connector just removed to the male connector of the Yacht Controller interface, and connect the female connector coming from the Yacht Controller interface to the “CLUTCH” connector of the MTU-Sturdy control unit, as illustrated in figure 6 .
Need help?
Do you have a question about the MAXIMO and is the answer not in the manual?
Questions and answers