Onboard Audio Function - Gigabyte GA-MA790FXT-UD5P User Manual

Onboard Audio Function

Enables or disables the onboard audio function. (Default: Enabled)
If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item
to Disabled.
Onboard LAN device
Onboard LAN1 Function
Onboard LAN1 Boot ROM
 SMART LAN1
Onboard LAN2 Function
Onboard LAN2 Boot ROM
 SMART LAN2
: Move
Enter: Select
F5: Previous Values
Onboard LAN1/2 Function (LAN1/2 Port)
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item
to Disabled.
Onboard LAN1/2 Boot ROM (LAN1/2 Port)
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
SMART LAN1/2 (LAN Cable Diagnostic Function)
Start detecting at Port.....
Part1-2 Status =
Part3-6 Status =
Part4-5 Status =
Part7-8 Status =
: Move
Enter: Select
F5: Previous Values
This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN
cable. This feature will detect cabling issue and report the approximate distance to the fault or short.
Refer to the following information for diagnosing your LAN cable:
When No LAN Cable Is Attached...
If no LAN cable is attached to the motherboard, the Status fields of all four pairs of wires will show
Open and the Length fields show 0m, as shown in the figure above.
GA-MA790FXT-UD5P Motherboard
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
Onboard LAN device
+/-/PU/PD: Value
F6: Fail-Safe Defaults
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
Open / Length
Open / Length
Open / Length
Open / Length
+/-/PU/PD: Value
F6: Fail-Safe Defaults
[Enabled]
[Disabled]
[Press Enter]
[Enabled]
[Disabled]
[Press Enter]
F10: Save
SMART LAN
= 0 m
= 0 m
= 0 m
= 0 m
F10: Save
- 52 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults