Gigabyte GA-MA790FXT-UD5P User Manual page 51

Disk/RAID Status
=== Disk Info ===
[Port] [Model]
Port 0
Port 1
=== RAID Info ===
[Volume] [Model]
: Move
Enter: Select
F5: Previous Values
This menu provides information on the connected hard drive(s) and RAID array.
Smart Backup Config
Smart Backup Config
Apply RAID Config
=== Disk Info ===
[Port] [Model]
Port 0
Port 1
=== RAID Info ===
[Level] [Capacity] [Member]
Performance 0GB
: Move
Enter: Select
F5: Previous Values
This menu allows you to configure a RAID array.
Smart Backup Config
Allows you to configure your SATA hard drives or to build a RAID array. Options are Performance
(RAID 0), Safe (RAID 1), Big (JBOD), and Normal (Port Multiplier)
Apply RAID Config
After configuring the Smart Backup Config item above, press <Enter> on this item for the
settings to take effect. When the "Apply RAID Config (Y/N)?" message appears, press <Y> to
confirm. (Note: If you want to erase an existing RAID array and set up a new array, make sure
to set Smart Backup Config to Normal first, and then select the RAID mode you want.)
(Note) When the hard drive(s) is set to Normal Multiplier mode, make sure to install the SATA
controller driver in the operating system for the hard drive(s) to be properly detected and to
support hot plug.
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
Disk/RAID Status
+/-/PU/PD: Value
F6: Fail-Safe Defaults
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
Smart Backup Config
+/-/PU/PD: Value
F6: Fail-Safe Defaults
[Capacity]
[Capacity] [Status]
F10: Save
[Performance (RAID 0)]
[Press Enter]
[Capacity]
F10: Save
- 51 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
.
(Note)
BIOS Setup