Gigabyte GA-K8V Ultra-939 User Manual page 26

9) IDE1 / IDE2 (IDE Connector)
An IDE device connects to the computer via an IDE connector. One IDE connector can connect to
one IDE cable, and the single IDE cable can then connect to two IDE devices (hard drive or optical
drive). If you wish to connect two IDE devices, please set the jumper on one IDE device as Master
and the other as Slave (for information on settings, please refer to the instructions located on the IDE
device).
10) SATA0_SB / SATA1_SB (Serial ATA Connector, Controlled by VT8237 or 8237R)
11) SATA0_SII / SATA1_SII (Serial ATA Connector, Controlled by SiI3512)
Serial ATA can provide up to 150MB/s transfer rate. Please refer to the BIOS setting for the Serial
ATA and install the proper driver in order to work properly.
GA-K8VNXP-939/GA-K8V Ultra-939 Motherboard
40
2
IDE2 IDE1
SATA0_SB / SATA1_SB
1 7
SATA0_SII / SATA1_SII
7 1
These SATA connectors support hot plug function.
- 26 -
39
1
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND