Set Supervisor/User Password - Gigabyte GA-8TRS350MT User Manual

Set Supervisor/User Password

CMOS Setup Utility -Co py right (C) 1984 -2004 Aw ard Software
}
Stan dard CM OS Features
}
Advanced BI OS Features
}
Inte grated Periphe rals
}
Powe r Manag ement Setup
}
PnP/PCI Con figurations
}
PC H ealth Status
}
Frequ ency /Voltage Con trol
ESC: Quit
F8: Q- Flash
When you select this function, the fol l owing message will appear at the center of the screen to assist
you in creating a password.
Type the password, up to eight characters, and press <Enter>. You will be asked to confirm the
password. Type the password again and press <Enter>. You may also press <Esc> to abort the
selection and not enter a password.
To disable password, just press <Enter> when you are prompted to enter password. A message
"PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password is
disabled, the system will boot and you can enter Setup freely.
The BIOS Setup program allows you to specify two separate passwords:
SUPERVISOR PASSWORD and a USER PASSWORD. When disabled, anyone may access
all BIOS Setup program function. When enabled, the Supervisor password is required for entering the
BIOS Setup program and having full configuration f i elds, the User password is required to access only
basic items.
If y ou select "System" at "Password Check" in A dvance BIOS Features Menu, you will be
prompted for the password every time the system is rebooted or any time you try to enter Setup Menu.
If you select "Set u p" at "Password Check" in Advance BIOS Features Menu, you will be prompted
only when you try to enter Setup.
GA-8TRS350MT Motherboard
Ente r Passw ord:
Chang e/Set/Dis able Pas sword
- 46 -
Top Perform ance
Load Fail-Sa fe Defa ults
Load Optimized Defa ults
Set Supervis or Pass word
Set U ser Pass word
Save & Exit Setup
Exit Without Saving
higf: Selec t Item
F10: Save & Exit Setup