UART Mode Select
This item allows you to determine which Infra Red(IR) function of Onboard I/O chip.
Normal
IrDA
ASKIR
SCR
UR2 Duplex Mode
This feature allows you to seclect IR mode.
This function will available when "UART Mode Select" doesn't set at Normal/SCR.
Half
Full
Onboard Parallel port
This feature allows you to select from a given set of parameters if the parallel port uses the onboard
I/O controller.
Disabled
378/IRQ7
278/IRQ5
3BC/IRQ7
Parallel Port Mode
This feature allows you to connect with an advanced printer via the port mode it supports.
SPP
EPP
ECP
ECP+EPP
ECP Mode Use DMA
This feature allows you to select Direct Memory Access(DMA) channel if the ECP mode selected.
This function will available when "Parallel Port Mode" set at ECP or ECP+EPP.
3
1
GA-8IPE1000MK(rev. 2.0) Motherboard
Set onboard I/O chip UART to Normal Mode. (Default Value)
Set onboard I/O chip UART to IrDA Mode.
Set onboard I/O chip UART to ASKIR Mode.
Set onboard I/O chip UART to SCR Interface.
IR Function Duplex Half. (Default Value)
IR Function Duplex Full.
Disable onboard LPT port.
Enable onboard LPT port and address is 378/IRQ7. (Default Value)
Enable onboard LPT port and address is 278/IRQ5.
Enable onboard LPT port and address is 3BC/IRQ7.
Using Parallel port as Standard Parallel Port. (Default Value)
Using Parallel port as Enhanced Parallel Port.
Using Parallel port as Extended Capabilities Port.
Using Parallel port as ECP & EPP mode.
Set ECP Mode Use DMA to 3. (Default Value)
Set ECP Mode Use DMA to 1.
- 44 -