Gigabyte GA-8IPE1000MK User Manual page 27

7) SATA0 / SATA1 (Serial ATA Connector)
You can connect the Serial ATA device to this connector, it provides you high speed transfer rates
(150MB/sec).
8) BAT (BATTERY)
Pin No.
7 1
SATA1
7 1
SATA0
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the
manufacturer's instructions.
If you want to erase CMOS...
1. Turn OFF the computer and unplug the power
cord.
2. Take out the battery gently and put it aside for
about 10 minutes (Or you can use a metal
object to connect the positive and negative pins
in the battery holder to make them short for one
minute).
3. Re-install the battery.
4. Plug the power cord and turn ON the computer.
- 23 - Hardware Installation Process
Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
+