Default Factory Settings - NETGEAR FVX538 - ProSafe VPN Firewall 200 Router Reference Manual

Reference Manual for the ProSafe VPN Firewall 200 FVX538
Figure 2-5: Login screen on the Web browser

Default Factory Settings

When you first receive your FVX538, the default factory settings will be set as shown in
below. You can restore these defaults with the Factory Defaults restore switch on the front panel —
see "The Router's Front Panel" on page
• Pressing this switch until the TEST LED blinks (approximately 10 seconds) causes the
firewall to restore all factory default settings and reboot.
• A shorter press and release causes the firewall to merely reboot.
Table 2-1. Factory Default Settings
User Name (case sensitive)
Password (case sensitive)
Time Zone Adjust for Daylight Saving TIme
2-10
2-6.
Feature
Built-in DHCP server
IP Configuration
Time Zone
SNMP
January 2005
Default
admin
password
DHCP server is enabled, issues addresses in the
default subnet
IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
GMT
Enabled
Disabled
Table 2-1
Introduction