NETGEAR FVX538 - ProSafe VPN Firewall 200 Router Reference Manual page 54

Reference Manual for the ProSafe VPN Firewall 200 FVX538
Click Setup Wizard on the WAN1 ISP Settings screen to get the Setup Wizard (WAN1)
b.
screen.
Click Next and follow the steps in the WAN1 Setup Wizard for inputting the configuration
c.
parameters from your ISP1 to connect to the Internet.
Note: If you choose not to use the Setup Wizard, you can manually configure your
Internet connection settings by following the procedure
Internet Connection" on page
Unless your ISP automatically assigns your configuration automatically via DHCP, you
will need the configuration parameters from your ISP as you recorded them previously in
"Record Your Internet Connection Information" on page
When the firewall successfully detects an active Internet service, the firewall's Internet
d.
LED goes on. The Setup Wizard reports which connection type it discovered, and displays
the appropriate configuration menu. If the Setup Wizard finds no connection, you will be
prompted to check the physical connection between your firewall and the cable or DSL
line. The options are:
Table 4-1. Internet connection methods
Connection Method
PPPoE
PPTP
DHCP (Dynamic IP)
Fixed IP
Set up the traffic meter for ISP1 if desired. See
e.
Desired)" on page
Note: At this point of the configuration process, you are now connected to the Internet
through WAN port 1. But you must complete the configuration process outlined in this
chapter to get the complete functionality of the dual WAN interface.
4-10
4-12.
Data Required
Login (Username, Password).
Login (Username, Password), Local IP, and PPTP Server IP.
No data is required.
IP address and related data supplied by your ISP.
4-13.
January 2005
"Manually Configuring Your
4-5.
"Programming the Traffic Meter (if
Connecting the FVX538 to the Internet