Step 3: Configure The Internet Connections To Your Isps (Required) - NETGEAR FVX538 - ProSafe VPN Firewall 200 Router Reference Manual

Reference Manual for the ProSafe VPN Firewall 200 FVX538
Figure 4-2: Login screen on the Web browser
For security reasons, the firewall has its own user name and password. When prompted, enter
2.
for the firewall user name and
admin
letters.The firewall user name and password are not the same as any user name or password
you may use to log in to your Internet connection.
Note: You might want to enable remote management at this time so that you can log in
remotely in the future to manage the firewall. See
Access" on page 8-9
a factory default reset.
Whenever you enable remote management, you are strongly advised to change your
password. See
procedure on how to do this.
Step 3: Configure the Internet Connections to Your ISPs
(Required)
The steps to configure the Internet connections to your ISPs are to configure WAN port 1 first and
then configure WAN port 2 second.
The steps to configure WAN port 1 are as follows:
1.
You should now be connected to the firewall. If you do not see the WAN1 ISP Settings
a.
screen shown in
upper left of the main menu.
4-8
password
for more information. Remote management enable is cleared with
"Changing the Passwords and Login Timeout" on page 8-9
Figure 4-3, click the WAN1 ISP link directly under WAN Setup on the
January 2005
for the firewall password, both in lower case
"Enabling Remote Management
Connecting the FVX538 to the Internet
for the