Default Factory Settings; Before You Change The Ssid And Wep Settings - NETGEAR FWG114P Reference Manual

Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P

Default Factory Settings

When you first receive your FWG114P, the default factory settings are shown below. You can
restore these defaults with the Factory Default Restore button on the rear panel. After you install
the FWG114P Wireless Firewall/Print Server, use the procedures below to customize any of the
settings to better meet your networking needs.
SSID broadcast
Wireless Card Access List for
Access Point Connections
Authentication Type

Before You Change the SSID and WEP Settings

Take the following steps:
For a new wireless network, print or copy this form and fill in the configuration parameters. For an
existing wireless network, the person who set up or is responsible for the network will be able to
provide this information. Be sure to set the Regulatory Domain correctly as the first step.
• SSID: The Service Set Identification (SSID) identifies the wireless local area network.
Wireless is the default FWG114P SSID. However, you may customize it by using up to 32
alphanumeric characters. Write your customized SSID on the line below.
Note: The SSID in the wireless firewall/print server is the SSID you configure in the
wireless adapter card. All wireless nodes in the same network must be configured with the
same SSID: ______________________________
• Authentication
Choose "Shared Key" for more security.
802.11b SSID, circle one: Open System or Shared Key
4-6
FEATURE DEFAULT FACTORY SETTINGS
SSID NETGEAR
RF Channel 11 until the Region is selected
Access Point Enabled
Enabled
All wireless stations allowed
WEP Security Disabled
Open System
M-10177-01
Wireless Configuration