Step 1: Enable The Dmz Port - NETGEAR FVX538 - ProSafe VPN Firewall 200 Router Reference Manual

Step 1: Enable the DMZ port

From the Main Menu of the browser interface, under Advanced, click on DMZ Setup to view the
DMZ Setup menu, shown below.
Figure 5-4: DMZ Setup screen
To enable and configure the DMZ port:
Click the Enable DMZ Port checkbox.
1.
Enter the IP Address and the Subnet mask. Make sure that the DMZ port IP address and LAN
2.
Port IP address are in different subnets.
If desired, enable a DHCP (Dynamic Host Configuration Protocol) server, providing TCP/IP
3.
configuration for all computers connected to the router's DMZ network.
If another device on your DMZ network will be the DHCP server, or if you will manually
configure all devices, select the Disable option under DHCP configuration. Select the DHCP
Relay option to configure the router as a DHCP relay.
• Starting IP Address - This box specifies the first of the contiguous addresses in the IP
address pool. 192.168.10.2 is the default start address.
LAN Configuration
Reference Manual for the ProSafe VPN Firewall 200 FVX538
January 2005
5-7