NETGEAR FVS318 - ProSafe VPN Firewall Router Reference Manual page 177

Click on the VPN Policies link under the VPN category link on the left side of the main menu.
4.
This will take you to the VPN Policies Menu page. Click Add Auto Policy. This will open a
new screen titled VPN – Auto Policy.
Figure E-7: NETGEAR FVL328 VPN v1.4 – Auto Policy (part 1)
– Enter a unique name to identify this policy. This name is not supplied to the remote VPN
endpoint. In our example we have used "to318" as the Policy Name. In the Policy Name
field type to318.
– From the IKE policy drop-down box, select the IKE Policy that was set up in the earlier
step – this being the FVS318 IKE Policy.
– From the Remote VPN Endpoint Address Type drop-down box, select IP Address.
– Type the WAN IP Address of Gateway A (14.15.16.17 in our example) in the Remote
VPN Endpoint Address Data field.
– Type 300 in the SA Life Time (Seconds) field.
– Type 0 in the SA Life Time (Kbytes) field.
– Check the IPSec PFS checkbox.
– From the PFS Key Group drop-down box, select Group 2 (1024 Bit).
– From the Traffic Selector Local IP drop-down box, select "Subnet addresses".
– Type the starting LAN IP Address of Gateway B (172.23.9.1 in our example) in the Local
IP Start IP Address field.
NETGEAR VPN Configuration of FVS318 or FVM318 to FVL328
Reference Manual for the Model FVS318 Broadband ProSafe VPN Firewall
M-10146-01
E-7