Netgear Vpn Configuration Fvs318 Or Fvm318 To Cisco Ios; Configuration Profile - NETGEAR FVS318 - ProSafe VPN Firewall Router Reference Manual

This appendix is a case study on how to configure a secure IPSec VPN tunnel from a NETGEAR
FVS318 or FVM318 to a Cisco IOS VPN product. This case study follows the VPN Consortium
interoperability profile guidelines (found at http://www.vpnc.org/InteropProfiles/Interop-01.html).
The configuration screens for the FVS318 and FVM318 are the same.

Configuration Profile

The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
Table F-1. Summary
VPN Consortium Scenario:
Type of VPN
Security Scheme:
Date Tested:
Model/Firmware Tested:
Gateway A
Gateway B
IP Addressing:
Gateway A
Gateway B

NETGEAR VPN Configuration FVS318 or FVM318 to Cisco IOS

NETGEAR VPN Configuration
FVS318 or FVM318 to Cisco IOS
Scenario 1
LAN-to-LAN or Gateway-to-Gateway (not PC/Client-to-Gateway)
IKE with Preshared Secret/Key (not Certificate-based)
April 2003
NETGEAR FVS318 firmware v A1.4 or FVM318 firmware v 1.1
Cisco IOS v 12.2
Static IP address
Static IP address
M-10146-01
Appendix F
F-1