NETGEAR FVS318 - ProSafe VPN Firewall Router Reference Manual page 76

Reference Manual for the Model FVS318 Broadband ProSafe VPN Firewall
1. Set up the two LANs to have different IP address ranges.
Note: The LAN IP address ranges of each connected network must be different. The
connection will fail if both are using the NETGEAR default address range of 192.168.0.x.
This procedure uses the settings in the configuration worksheet above. A blank worksheet you
can use to record your settings is provided on
Log in to the FVS318 on LAN A at its default LAN address of
a.
default user name of
the main menu Advanced section to display the LAN TCP/IP Setup menu shown below.
LAN A
Figure 6-7: Configuring the Local LAN (A) via the LAN IP Setup Menu
For this example, configure the FVS318 settings on LANs A and B as follows:
b.
Network Configuration Settings
Network
LAN A
LAN B
Note: If port forwarding, trusted user, or static routes are set up, you will need to change
these configurations to match the 192.168.3.x network as well.
Click Apply. Because you changed the Firewall's IP address, you are now disconnected.
c.
6-12
and password of
admin
LAN IP Address
192.168.3.1
192.168.0.1
M-10146-01
page 6-31.
. Click the LAN IP Setup link in
password
LAN B
Subnet Mask FQDN or Gateway IP
255.255.255.0
255.255.255.0
http://192.168.0.1 with its
(WAN IP Address)
24.0.0.1
10.0.0.1
Virtual Private Networking