U-Line H-11028 Manual
U-Line H-11028 Manual

U-Line H-11028 Manual

Air scrubber

Advertisement

Available languages

Available languages

H-11028
AIR SCRUBBER
• When using this product in a containment area,
turn off all sources of power to open combustion
appliances such as fireplaces, boilers, furnaces,
water heaters and HVAC systems to avoid the risk of
backdrafting deadly carbon monoxide fumes.
• This unit complies with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy,
and, if not installed and used in accordance with
these instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
PAGE 1 OF 6
1-800-295-5510
uline.com
SAFETY
• The unit must be electrically grounded. Use only on
GFCI protected receptacles.
• Connect to a properly grounded outlet only. Do
not cut off the grounding prong. Do not use with
an adapter.
• Do not use with extension cords.
• Do not use with damaged cord or plug.
• Unplug cord from outlet when not in use or when
servicing unit.
• Keep motor and electrical parts dry.
• Do not use outdoors. For indoor use only.
• Do not handle plug or unit with wet hands.
• Do not operate unit in standing water.
• If unit is not working as it should, has been
dropped, damaged, left outdoors or exposed
to water, contact Uline Customer Service at
1-800-295-5510.
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
1123 IH-11028

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the H-11028 and is the answer not in the manual?

Questions and answers

Summary of Contents for U-Line H-11028

  • Page 1 Para Español, vea páginas 3-4. Pour le français, consulter les pages 5-6. H-11028 1-800-295-5510 uline.com AIR SCRUBBER SAFETY • When using this product in a containment area, • The unit must be electrically grounded. Use only on turn off all sources of power to open combustion GFCI protected receptacles.
  • Page 2: Maintenance

    SETUP Place unit with the handle up. Figure 1 2. Remove inlet cover. (See Figure 1) Front Back IMPORTANT! Ensure that neither the inlet nor the outlet are obstructed before turning power on. (See Figure 1) 3. Unwind power cord completely. 4.
  • Page 3 H-11028 800-295-5510 uline.mx PURIFICADOR DE AIRE INDUSTRIAL SEGURIDAD • Al utilizar este producto en un área de contención, • La unidad se debe conectar eléctricamente apague todas las fuentes de energía de aparatos a tierra. Utilice solamente en receptáculos de combustión como chimeneas, calderas, hornos, protegidos GFCI.
  • Page 4: Mantenimiento

    CONFIGURACIÓN 1. Coloque la unidad con el asa hacia arriba. Diagrama 1 2. Retire la cubierta de la entrada. (Vea Diagrama 1) Frente Posterior ¡IMPORTANTE! Asegúrese de que ni la entrada ni la salida estén obstruidas antes de encender. (Vea Diagrama 1) 3.
  • Page 5 H-11028 1-800-295-5510 uline.ca ÉPURATEUR D'AIR SÉCURITÉ • Pendant l'utilisation de ce produit dans une zone • L'appareil doit être mis à la terre. Utilisez-le de confinement, éteignez toutes les sources uniquement avec des prises de courant protégées d'alimentation des appareils à combustion par un disjoncteur de fuite à...
  • Page 6: Installation

    INSTALLATION Placez l'appareil avec la poignée vers le haut. Figure 1 2. Retirez le couvercle d'entrée. (Voir Figure 1) Avant Arrière IMPORTANT! Assurez-vous que ni l'entrée ni la sortie ne sont obstruées avant de mettre l'appareil sous tension. (Voir Figure 1) 3.

Table of Contents