Download Print this page
U-Line H-8041 Quick Start Manual
U-Line H-8041 Quick Start Manual

U-Line H-8041 Quick Start Manual

Compact auto floor scrubber
Hide thumbs Also See for H-8041:

Advertisement

Quick Links

π
H-8041
COMPACT AUTO FLOOR SCRUBBER
NOTE: This guide is intended for quick reference
only and does not replace the instruction
manual. Before using this machine, read full
instruction manual included with machine
packaging.
NOTE: Battery must be fully charged before first
use.
(See Instructions)
FILL TANK
1. Add water and detergent into the tank.
(See Figure 1)
Figure 1
NOTE: Use a non-foaming detergent with a
pH range between 7-11. Be sure to follow the
detergent instructions for proper dilution.
2. Open flow from detergent tank by pushing lever up
to horizontal position. Leave open. (See Figure 2)
Figure 2
BEGIN WORK
1.
Lower squeegee by pushing handle down.
(See Figure 3)
Figure 3
PAGE 1 OF 3
1-800-295-5510
uline.com
OPERATION
2. Turn on unit and press brush button. All lights will light
up and unit is fully functional.
(See Figures 4 and 5)
Figure 4
3. After use, empty the recovery tank by using the
attached drain hose. (See Figure 6)
Figure 6
4. Once finished, charge the battery.
NOTE: The battery should be charged after
every use, and once every three weeks to
maintain battery life.
WHEN FINISHED CLEANING
1. Turn machine off by pressing the On/Off button for at
least four seconds.
2. Raise squeegee.
3. Close the detergent tap.
4. Empty the recovery tank (see Maintenance).
5. Charge the battery (see Maintenance).
Figure 5
0620 RH-8041

Advertisement

loading
Need help?

Need help?

Do you have a question about the H-8041 and is the answer not in the manual?

Questions and answers

Summary of Contents for U-Line H-8041

  • Page 1 π H-8041 1-800-295-5510 uline.com COMPACT AUTO FLOOR SCRUBBER OPERATION NOTE: This guide is intended for quick reference 2. Turn on unit and press brush button. All lights will light only and does not replace the instruction up and unit is fully functional.
  • Page 2 MAINTENANCE DAILY MAINTENANCE 5. Check battery charge. (See Figure 12) Figure 12 Use the attached drain hose to empty the dirty water from the recovery tank. (See Figure 7) Figure 7 6. To recharge batteries, plug in battery charger using electrical cord provided with machine.
  • Page 3 BATTERY CHARGER VISUAL SIGNALS NOTE: Refer to Battery Charger manual for full instructions. (See Instructions) OPERATING SIGNALS TROUBLESHOOTING Red LED Flashing (twice) Yellow LED Flashing Battery charger is set to charge. Unsuitable battery OR battery not connected OR output short circuit. Red LED On First phase of charge in progress.