Turning On The Projector - Casio SC-210 User Manual

Getting Ready

Turning On the Projector

Before performing any of the operations in this section, make sure you first set up the projector
and connect to an output device.
AC Power Cord Precautions
Use the AC power cord that comes with the projector.
Make sure that you use a power source with the same voltage as that specified for the
projector.
Do not share the outlet supplying power to the projector with other devices. If you are using
an extension cord, make sure that the ampere rating of the extension cord is compatible with
the power consumption value of this projector.
Never use the power cord while it is still bundled together.
Never place objects on top of the power cord and do not step on it.
Never pull on the power cord. When unplugging it, grasp the plug.
Use a conveniently located power outlet that you can reach easily when you need to unplug
the projector.
If you need more information about the power supply, contact your original dealer or
authorized CASIO service center.
To turn on the projector
1.
Use the bundled AC power cord to plug
the projector into a power outlet.
Plugging into a power outlet causes the
three indicators on the top of the projector
to light amber. After a short while, two of
the indicators will go out and only the
POWER/STANDBY indicator will remain lit
amber, which indicates the standby state.
Note that the projector will not turn on if
you press the [
three indicators are lit amber. Wait until the
projector is in the standby state before
trying to turn it on.
This product is also designed for IT power distribution system with phase-to-phase voltage
230V.
2.
Turn on the computer or video device that is connected to the projector.
3.
If the projector's lens cover is closed, open it.
Do not try to force the lens cover open past horizontal. Doing so creates the risk of
malfunction.
4.
Press the [ ] (power) key.
This causes the POWER/STANDBY indicator to flash green, which indicates that the
projector is warming up.
After warm up is complete, POWER/STANDBY indicator stops flashing and remains lit
green, and the projector starts projecting an image from the device connected to it.
A "Language" window will be projected the first time you turn on the projector. Use the
procedure under "Specifying the Display Message Language" on the page E-21 to
configure the language settings.
] (power) key while all
Power supply connector
E-20
Bundled AC power
cord
The shape of the
plug depends on your
geographical area.