Casio SC-210 User Manual page 37

Indicator/Error Message
POWER : Amber flashing
Red steady
TEMP : Red steady
LAMP : –
Message : –
POWER : Amber flashing
Red steady
TEMP : Red flashing
(0.5-second interval)
LAMP : Red flashing
(0.5-second interval)
Message : –
POWER : Amber flashing
Red steady
TEMP : Red flashing
(2-second interval)
LAMP : Not lit or red flashing
Message : –
POWER : Amber flashing
Red steady
TEMP : Amber flashing
(1-second interval)
LAMP : –
Message : –
POWER : Green steady
TEMP : –
LAMP : Red flashing
(1-second interval)
Message : It is time to replace
the lamp. Use the
procedure in the
User's Guide to
replace the lamp as
soon as possible.
Description and Required Action
The projector was turned off automatically due to some
problem that was probably caused by external digital noise or
some other reason. Confirm that the POWER/STANDBY
indicator is lit red (without flashing). After checking the
POWER/STANDBY indicator, disconnect the power cord from
the projector and wait for all of the projector's indicators to go
out. Next, reconnect the power cord and turn projector power
back on.
If the error occurs again when you turn power back on,
contact your retailer or nearest authorized CASIO Service
Center.
The projector was turned off automatically because the lamp
turned off or did not turn on. After confirming that the
POWER/STANDBY indicator is lit red (without flashing), unplug
the power cord. Wait for a short while and then plug it back
in and turn on the projector again.
If the error occurs again when you turn power back on, wait
until the projector cools down and then replace the lamp
(page E-29).
If the lamp does not light after you replace it, contact your
retailer or nearest authorized CASIO Service Center.
Power has turned off automatically due to a projector memory
error. Confirm that the POWER/STANDBY indicator is lit red
(without flashing). After checking the POWER/STANDBY
indicator, disconnect the power cord from the projector and
wait for all of the projector's indicators to go out. Next,
reconnect the power cord and turn projector power back on.
If the error occurs again when you turn power back on,
contact your retailer or nearest authorized CASIO Service
Center.
Power has turned off automatically because the lamp cover is
open. Perform the following steps.
1 After confirming that the POWER/STANDBY indicator is lit
red (without flashing), disconnect the power cord from the
projector.
2 Check to make sure that the lamp cover is closed.
3 Plug the power cord back in and turn the projector back
on again.
If the error occurs again when you turn power back on,
contact your retailer or nearest authorized CASIO Service
Center.
It is time to replace the lamp. Replace the lamp following the
"
steps under Replacing the Lamp" (page E-29). Press the
[ESC] key to clear the warning message.
E-37
Troubleshooting