Turning Off The Projector - Casio SC-210 User Manual

Getting Ready

Turning Off the Projector

When you turn off the projector, the lamp goes out and the projector goes into a cool
down state. Note that you will not be able to turn the projector back on again while it is
cooling down.
The projector may remain quite hot for a while after you turn it off. Take care when moving
the projector or otherwise handling it after use. See "Precaution when Handling the Projector
after Use" (page E-8) for more information.
Make sure that the projector is cooled down sufficiently before storing it.
To turn off the projector
1.
Press the [ ] (power) key.
This causes the confirmation message "Do you want to turn off the projector?" to appear
in the center of the projection screen.
If you do not turn off the projector the confirmation message will disappear automatically
after about 10 seconds. The confirmation message will also disappear if you press [ESC]
key.
2.
To turn off the projector, press the [
confirmation message.
This causes the projector lamp to go out and stops projection.
Also the POWER/STANDBY indicator starts to flash amber, which indicates that the
projector is cooling down.
The projector will not turn back on again while it is cooling down.
After cool down is finished, the POWER/STANDBY indicator on the top of the projector
will light amber, which indicates the standby state. You can now turn the projector back
on, if you want.
3.
After checking to make sure that the POWER/STANDBY indicator has stopped flashing
amber and remains lit, unplug the AC power cord from the power outlet.
This causes the POWER/STANDBY indicator to go out.
4.
After ensuring that the projector and the connected computer or video device are
turned off, disconnect the connecting cables from the projector and the connected
device.
5.
Close the lens cover.
Auto Power Off
Auto Power Off automatically turns off the projector whenever there is no input signal, and no
operation is performed on the projector for about 30 minutes. When Auto Power Off is triggered,
the projector first enters a cool down state, the same as it does when you press the [
(power) key to turn it off.
While Direct Power On (page E-21) is enabled, the projector will turn off automatically if no
key operation is performed and no signal input is received within about 10 minutes after it
is turned on.
] (power) key again in response to the
E-22
]