Direct Power On - Casio SC-210 User Manual

If the Eco Mode is turned on, the LAMP indicator will light green when warm up starts.
If the projector is hot when you plug the AC power cord into a power outlet, it will go into
a cool down state. The cool down state is indicated by the POWER/STANDBY indicator
flashing orange.
Note that the projector will not turn on until cool down is complete, even if you press the
[ ] (power) key.
The projector will turn on and enter the standby state after cool down is complete.
The password feature lets you limit use of the projector to specific individuals. For more
information, see "Option Settings 1
(UsersGuide_English.pdf) on the CD-ROM that comes with the projector.
Specifying the Display Message Language
A "Language" window will be projected the first time you turn on the projector. Use the menu
on this screen to specify the display language you want to use.
1.
Use the cursor [ ] and [ ] keys to highlight the language you want to use.
2.
Press the [ENTER] key.

Direct Power On

You can configure the projector so it powers up automatically as soon as you plug it into a
power source. With this "Direct Power On" feature, you do not even need to press the [
(power) key. To enable Direct Power On, display the Setup Menu, and then change the "Direct
Power On" setting to "On".
When you have Direct Power On enabled, do not leave the projector plugged into an
electrical outlet while it is turned off. If you do, there is the chance that it (and the lamp)
might turn on automatically when power is restored after being cut off by a power outage,
tripping of a breaker, etc.
Direct Power On causes the projector to turn on automatically as soon as it is plugged into
a power outlet. This greatly reduces the amount of time it takes until you are ready to
start projecting. Note, however, that the actual startup sequence (Standby State
On Warm Up
whether Direct Power On is enabled or disabled. The only difference is what triggers the
sequence (plugging in or pressing the [
sequence that the projector performs when you plug it into a power source, see "To turn
on the projector" on page E-20.
For details about configuring the Direct Power On setting, see "Direct Power On" under
"Option Settings 1 Main Menu" in the "User's Guide".
Power On Password" in the User's Guide
Projection Starts) that the projector performs is the same, regardless of
] (power) key). For details about the startup
E-21
Getting Ready
]
Power