Selecting A Direct-To Waypoint - Garmin G900X Pilot's Manual

The "direct-to" navigation feature provides a quick method of setting a GPS course to a destination waypoint.
Once a direct-to is activated, the G900X establishes a point-to-point course line from the present position to the
selected direct-to destination. Course guidance is provided until the direct-to is cancelled or replaced by a new
destination.

SELECTING A DIRECT-TO WAYPOINT

A direct-to waypoint can be selected in the following ways:
• By identifier, facility, or the name of a city
• From the active flight plan or nearest airports list
• From a waypoint field, waypoint page, or highlight shortcut
Selecting and activating a direct-to destination by entering an identifier:
1) Press the Direct-to (
2) Enter the destination waypoint identifier (Figure 5-28).
3) Press the ENT Key to confirm the identifier. The 'Activate?' field is highlighted (Figure 5-29).
4) If no altitude constraint or course is desired, press the ENT Key to activate. To enter an altitude constraint,
proceed to step 5.
5) Turn the large FMS Knob to place the cursor over the 'VNV' altitude field (Figure 5-30).
190-00726-00 Rev. A
) Key.
Figure 5-28 Entering an Identifier
Figure 5-29 Activate Field
Garmin G900X Pilot's Guide
GPS NAVIGATION
Activate Field
5-39