Troubleshooting; Basic Troubleshooting Tips - HP J4865A Installation And Getting Started Manual

Troubleshooting

This chapter describes how to troubleshoot your Series 4100gl Switches. This
document describes troubleshooting mostly from a hardware perspective.
You can perform more in-depth troubleshooting using the software tools
available with the switch, including the full-featured console interface, the
built-in web browser interface, and HP ProCurve Manager for Hubs &
Switches, the SNMP-based network management tool. For more information,
see the chapter on "Troubleshooting" in the Management and Configuration­
Guide that is on the documentation CD-ROM included with your switch.
This chapter describes the following:

Basic Troubleshooting Tips

Most problems are caused by the following situations. Check for these items
first when starting your troubleshooting:
basic troubleshooting tips
diagnosing with the LEDs
Proactive Networking tools
hardware diagnostic tests
restoring the factory default configuration
downloading new code
HP Customer Support Services
Faulty or loose cables. Look for loose or obviously faulty connections.
If they appear to be OK, ensure the connections are snug. If that does not
correct the problem, try a different cable.
Non-standard cables. Non-standard and miswired cables may cause
network collisions and other network problems, and can seriously impair
network performance. Use a new correctly-wired cable or compare your
cable to the cable in appendix B, "Cables and Connectors" for pinouts and
correct cable wiring. A category 5 cable tester is a recommended tool for
every 100Base-TX and 1000Base-T network installation.
(page 4-1)
(page 4-4)
(page 4-9)
(page 4-10)
(page
(page 4-13)
(page 4-13)
4
4-12)
4-1