Rack Mounting Switch - Cisco Business Series Manual

Rack Mounting Switch

• Computer running on of the following browsers: Microsoft Edge or Firefox (version 74 or 73 or higher),
Warning Suitable for installation in information Technology Rooms in accordance with Article 645 of the national
Electric Code and NFPA 75.
Rack Mounting Switch
You can mount the switches on any standard size, 19-inch (about 48 cm) wide rack. The switch requires 1
rack unit (RU) of space, which is 1.75 inches (44.45 mm) high.
Caution For stability, load the rack from the bottom to the top, with the heaviest devices on the bottom. A top-heavy
rack is likely to be unstable and might tip over.
To install the switch into a 19-inch standard chassis:
Step 1
Place one of the supplied brackets on the side of the switch so that the four holes of the brackets align to the screw holes,
and then use the four supplied screws to secure it.
Step 2 Repeat the previous step to attach the other bracket to the opposite side of the switch.
Step 3
After the brackets are securely attached, the switch is now ready to be installed into a standard 19-inch rack.
Get To Know Your Switch
2
• Shaft diameter: 3.94 mm
or Chrome (version 80 or 79 or higher), or Safari over MAC (version 12.1 and higher) for using the
web-based interface or the console port to manage your switch.
Get To Know Your Switch