Cisco WS-C2960G-8TC-L Configuration page 9

configuration on the switch. When posing questions, the setup script uses brackets
([ and ]) to indicate default values. Leaving these answers blank (that is, not supplying
an answer) results in the script accepting the value indicated in brackets for the
configuration component. In the script, you can configure the switch's hostname, set
up a Privilege EXEC password, assign a password for the virtual type terminals (VTYs),
and set up an IP address for a VLAN interface to manage the switch remotely.
If a switch boots up without
a configuration in NVRAM, the setup script
Here's an example of this script:
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: yes
Configuring global parameters:
Enter host name [Switch]:
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: cisco
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: boson
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: sanjose
Configure SNMP Network Management? [no]:
Current interface summary
(System Configuration Dialog) will be
presented to the administrator.
365
Switch Startup