Cisco WS-C2960G-8TC-L Configuration page 10

366
Chapter 12: Initial Switch Configuration
Interface
Vlan1
FastEthernet0/1
FastEthernet0/2
.
.
.
FastEthernet0/24
GigabitEthernet0/1
GigabitEthernet0/2
Enter interface name used to connect to the
management network from the above interface summary: vlan1
Configuring interface Vlan1:
Configure IP on this interface? [no]: yes
IP address for this interface: 192.168.1.253
Subnet mask for this interface [255.255.255.0] :
Class C network is 192.168.1.0, 24 subnet bits; mask is /24
Would you like to enable as a cluster command switch? [yes/no]: no
The following configuration command script was created:
hostname Switch
enable secret 5 $1$.N.L$t4q9Jw5DTffPTPE.KkKNX/
enable password boson
line vty 0 15
password sanjose
no snmp-server
interface Vlan1
no shutdown
ip address 192.168.1.253 255.255.255.0
!
interface FastEthernet0/1
.
.
.
interface GigabitEthernet0/1
!
interface GigabitEthernet0/2
end
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
IP-Address
unassigned
unassigned
unassigned
unassigned
unassigned
unassigned
OK? Method Status
YES unset up
YES unset down
YES unset down
YES unset down
YES unset down
YES unset down
Protocol
down
down
down
down
down
down